aquamatic-lift-motor — Lift Wire hardware

Aquamatic lift motor

Aquamatic

Verify

Aquamatic lift motors are typically single-phase reversible with an external start capacitor. Wiring usually follows the AO Smith T1..T8 convention — VERIFY against the motor's own diagram before energizing.

Type: capacitor-start
Voltage: 115V / 230V
HP range: 1/2 – 1 HP
Reversible: Yes
Reverse: Swap start-winding leads to reverse. Most follow T5 ↔ T8, but confirm on the motor plate.

Disconnect power at the panel and verify with a meter before wiring.

Wiring combos using this

Momentary drum → Aquamatic lift motor, 230V
Spring-return drum switch. Operator must hold UP or DOWN — safer when limit switches are absent or unreliable.